![]() Program calls program with as first parameter the configuration file. version Output version information and exit. Machinetype has influence on both the videocard and the available ![]() Svga_et3000, svga_et4000, svga_paradise, vesa_nolfb, vesa_oldvbe. Valid choicesĪre: hercules, cga, tandy, pcjr, ega, vgaonly, svga_s3(default), Machinetype Setup dosbox to emulate a specific type of machine. exit dosbox will close itself when the DOS program specified by Langfile Start dosbox with the language specified in langfile. Multiple configfiles can be present at the Thisįile has a section in which you can put commands you wish to execute on A command can be: an Internal Program, a DOS command or anĬonfigfile Start dosbox with the options specified in configfile. c command Runs the specified command before running file. Specified scaler even if it might not fit. Scaler Similar to the -scaler parameter, but tries to force usage of the See theĬonfiguration file for the available scalers -forcescaler Scaler Uses the graphical scaler specified by scaler. securemode Same as -noautoexec, but adds -securemode at theĮnd of AUTOEXEC.BAT (which in turn disables any changes to how theĭrives are mounted inside dosbox) -userconf Load the configuration file located in ~/.dosbox. noautoexec Skips the section of the loaded configuration file. ![]() startmapper Start the internal keymapper on startup of dosbox. fullscreen Start dosbox in fullscreen mode. OPTIONSĪ summary of options is included below. If it is a directory, a DOS session will run with theįor an introduction type INTRO inside dosbox. The optional file argument should be a DOS executable or aĭirectory. This manual page briefly documents dosbox, an x86/DOS Dosbox - an x86/DOS emulator with sound/graphics SYNOPSISĭosbox [-scaler
0 Comments
Leave a Reply. |